exhaust port

英 [ɪɡˈzɔːst pɔːt] 美 [ɪɡˈzɔːst pɔːrt]

排气口;排出孔

机械



双语例句

  1. Exhaust port ignition cleaner
    排气管点火废气净化系统
  2. The Isolated exhaust port allows the used compressed air to be piped outside the work area for Clean room compatibility.
    独立的排气装置允许使用压缩的空气为乾净的空间兼容在工作区外边以管子输送。
  3. At least this design has a larger exhaust port than the inlet port, even if not by much.
    至少这种设计有一个较大的排气口比进气道,即使不是由得多。
  4. Around the top of chassis to allow a certain space, in particular, attention should be paid to the various chassis air intake and the exhaust port.
    机箱的周围的顶部要留有一定的空间,尤其要注意机箱上的各个入气口和排气口。
  5. Position the slot located in the upper end of replacement grille at the exhaust port and insert edge in the slot.
    固定位于排气窗处的更换格删上部末端的槽并且将边插入到槽中。
  6. Exhaust process: compressed gases to the exhaust port, to complete a working cycle.
    排气过程:压缩气体移到排气口,完成一个工作循环。
  7. Compression process: With the rotor rotation, compression chamber volume decreases, the gas compressed with the compression chamber until the exhaust port to the forefront.
    压缩过程:随着转子旋转,压缩腔容积不断减小,气体随压缩直至压缩腔前沿转至排气口。
  8. Study on The Ceramic Coated Steel Exhaust Port for Single Cylinder Head
    钢壳陶瓷喷涂隔热排气道气缸盖单缸试验研究
  9. The exhaust gas is leaded to single intake port by the guided jet and achieves stratification with fresh mixture by using tumble motion of the engine in the cylinder.
    用废气导入管将废气引到单侧进气门处,利用四气门汽油机的缸内气体滚流运动,实现废气与新鲜可燃混合气的分层。
  10. HC emissions from engines are formed when a fraction of the fuel escapes combustion and flows out with the burned products. Post combustion oxidation in the cylinder and exhaust port consumes a part of this fuel and plays an important role in determining exhaust emission levels.
    部分燃料逃离主燃烧与燃烧产物一起排出气缸,形成了发动机的HC排放,HC在气缸和排气系统内的氧化程度决定了发动机的排放水平。
  11. Research on key technology of insulated cylinder head with ceramic coating steel shell exhaust port and its application
    钢壳陶瓷排气道气缸盖中试关键技术研究与应用
  12. An Investigation into Influences of Exhaust port Heat Insulating Methods on Total Temperature Field of Cylinder Head
    排气道隔热方式对气缸盖整体温度场影响的研究
  13. The study on insulation effect on cylinder head with ceramic exhaust port
    陶瓷排气道缸盖隔热效果的研究
  14. A CFD Study on the Effect of Exhaust Port to the Oxidation of HC in Gaseous Fuel Engine
    气体燃料发动机排气道中HC氧化的CFD研究
  15. Experimental results show that the position of the converter nearer to the exhaust port, the retard ignition timing and the higher idle speed can promote the catalytic converter light-off.
    试验结果表明,催化转化器的位置距排气口近可提高排气温度,大大提高催化转化器的转化效率;推迟点火提前角和提高怠速转速均有利于使催化转化器进入快速起燃状态。
  16. The calculation formula for determining the exhaust air rate of main air port has been given out as a reference to the project design.
    提出了确定主风口侧排风量的计算公式;为工程设计提供了参考依据。
  17. Mathematical Model of Intake and Exhaust Port Exterior of Cylinder Head
    气缸盖气道外形的数学模型
  18. A ceramic-coated steel shell is cast into the exhaust port of cylinder head in order to reduce the thermal load.
    为了降低发动机气缸盖的热负荷,在气缸盖排气道内铸入外壁喷涂陶瓷的钢壳。
  19. Defects of burning with fixed air-gas ratio in the whole burning period are found, according to analysis of the heat balance and shortage of turbulent convection caused by top exhaust port.
    根据梭式窑烧成的热平衡分析,指出整个烧成周期采用固定空燃比来控制煅烧的缺陷性;
  20. Time Resolved Sampling and Tracer Injection Studies Related to Exhaust Port Hydrocarbon Oxidation
    发动机排气口快速取样及示踪HC喷射的研究
  21. The results showed that the jacket of the injector, the inlet port, the exhaust port, the valve guides, the jobbing plate and the strengthen rib could transfer and disperse the explosive pressure acting on the cylinder head by different mechanisms.
    研究结果表明:气缸盖中的喷油器护套、进排气道、气门导管座孔、中隔板和加强筋通过不同的形式,传递并分散了作用在气缸盖上的燃气爆发压力;
  22. In this paper, we studied The effect of exhaust port to the oxidation of hydrocarbon ( HC) and its influence to the formation of formaldehyde in gaseous fuel engine using CFD software FLUENT coupled with detailed chemical kinetic mechanism.
    利用计算流体力学(CFD)软件耦合详细化学反应机理对气体燃料发动机排气过程中未燃HC在排气道的氧化及对甲醛(CH2O)生成的影响进行了研究。
  23. The result shows HC exists oxidation in the exhaust port, HC concentration decreases about 30%;
    研究表明,未燃HC在排气道存在氧化反应,浓度约减少30%;
  24. Study on Steel Shell Cast in Exhaust Port of cylinder Head for Thermal Isolation with CAD/ CAM
    发动机隔热用排气道钢壳的CAD/CAM
  25. The influence of the wind rate ( fresh air rate and exhaust air rate) of the main air port on the noise spreading from inside to outside in large-scale all-around hotel was discussed.
    用试验和理论分析了大型综合性酒店类建筑物主风口总风量(新风+排风)对该侧楼外噪声的影响。
  26. A Study on Exhaust Port Hydrocarbon Oxidation
    火花点火式发动机排气口HC氧化的研究
  27. The Determination of the Airflow Exhaust Port of the Air Impact Moulding
    冲击造型时压缩空气排放口面积的确定
  28. Subsequently, the geometrical parameters of the scavenging port and exhaust port were evaluated by introducing the new mathematical models and the traditional statistical solutions of the specific time area.
    然后,用所建的数学模型以及传统二冲程内燃机气口比时面值的统计规律,预测排气口和扫气口的几何参数。
  29. MWM engine add an exhaust port at a four-stroke engine cylinder wall, and it be controlled to opening or close by a valve, this structure can make the engine has different working mode by different valve working together.
    MWM发动机在普通四冲程发动机的气缸侧壁增加了一个排气口,且由气门控制其开闭,通过处于不同位置气门的配合工作,从而实现其各种工作模式和工作过程。
  30. Improve the original calculation software and increase multi-node exhaust port of the calculation program, the input interface, the data analysis interface and so on.
    对原有烟流计算软件进行改进,增加多节点排烟计算程序,对输入界面,数据分析界面进行完善。